[kagemusha]

@Zynewave wrote:

When I want to set the volume of a track group or for any track to a certain percentage it is written in the parameter file as curves/peaks for that moment. but it would be useful if you could also set a global volume >> if you move the volume that it makes that percentage for the whole timeline.

I am not entirely sure I understand what you mean. Could you describe it differently?

I found what the “problem” was:

Wat I meant was that if you move the the volume slider in for example the beginning of the region/part that not the whole volume for the remainder was increased >> eg I was getting a peak but the rest of the volume was staying low. But the reason I foundt was that , although the curve was a flat horizontal on a certain percentage, there were some break point in the curve. Of cource if I moved the volume up it went up till the next breakpoint >> a peak
I think this is a side efect of the “no read/write” method (which is pretty good). when I move the volume to check something out, the curve reacts, but when I put back the volume where it was, >> a breakpoint is created. I’m not always aware of that.

I still think you need to implement a way that you can move a volume (or any parameter) without it has effect on the curve (modifier key)

Because in the current state everything is written, and even if you don’t have curve changes they getting breack points every time you do something and roll back.

About the parameter events.
I remember that when I recorded I was getting all kind of little regions in my tracks with a dial on it for every change in the parameter. I know I could choose if I wanted a curve or a parameter event while recording.
I don’ t see the way anymore how to do this?